J-965

Outlet tapped with either AWWA taper (C.C.) or AWWA I.P. thread (F.I.P.T.)
For use on A-C** pipe, cast iron or ductile iron pipe and C900 PVC pipe
200 psig (1379 kPa/14 bar) maximum working pressure
Brass body
304L stainless steel straps
Roll strap threads
O-ring sealed outlet
1/2" thru 1" tap sizes
Meets all applicable parts of ANSI/AWWA C800
NSF 61 Certified

Parts

Nominal Pipe Size in Inches	Pipe O.D. Range*		Thread Type	Tap Size
	Inch	mm		3/4" Tap Part Number	1" Tap Part Number
4"	4.47-5.32	121.0-135.0	CC	38-1389	38-1390
			IP	38-1386	38-1387
6"	6.84-7.45	174.0-189.0	CC	38-1395	38-1396
			IP	38-1392	38-1393
8"	8.99-9.67	229.0-245.0	CC	38-1401	38-1402
			IP	38-1398	38-1399
10"	11.04-12.12	281.0-307.0	CC	38-1406	38-1407
			IP	-	38-1405
12"	13.14-14.58	334.0-370.0	CC	38-1410	38-1411
			IP	38-1408	38-1409

*A-C pipe, classes 150-200 per ASTM C295 and AWWA C400 – actual O.D. of pipe being used must fall within the pipe O.D. range listed in the preceding charts. Centrifugally cast pipe, classes 50-250 per ANSI/AWWA C102/A21.2; ANSI/AWWA C106/A21.6; ANSI/AWWA C108/A21.8, and Federal specification WW-P-421. Ductile iron pipe, classes 50-56 per ANSI/AWWA C151/A21.51; Cast iron O.D. PVC plastic pipe per AWWA C900.

**The outside diameter of A-C pipe varies from manufacturer to manufacturer, to make certain you select the proper clamp: 1) Determine the O.D.of the pipe at the point of saddle installation; 2) From the pipe O.D. range column of the above chart,choose a saddle that has a pipe O.D. range that includes the determined pipe diameter.